โพสเมื่อ
ชื่อสินค้า
Melt Pressure Transducer Simulator
รายละเอียด:
The Terwin pressure transducer simulator has been designed as a service aid to engineers that are involved in the extrusion of plastics, rubber and food.
Should a fault occur on an extrusion pressure monitoring / control system, the simulator will enable the plant engineer to check the cable assembly and associated indicator / controller / signal conditioner by simply plugging the transducer cable assembly into the simulator and checking all the functions with the eleven point rotary switch.
Specifications
-Accuracy ±0.25%
-Full Scale Output Nominal 3mV/V
-Configuration 350 ohm Wheatstone bridge
-Input Resistance 350 ohm ±0.5%
-Output Resistance 350 ohm ±0.5%
-Range 0-100% of F.R.O. in 10% steps
-Zero Balance ±0.25% of F.R.O.
-Calibration Type 6-wire 80% Negative Shunt
-Excitation 5 – 12V D.C.
.
.
.
ติดต่อสอบถามเพิ่มเติมได้ที่
โทร : 02-3286878
Line : @techquality
Website : www.tech-quality.com
ลูกค้าสัมพันธ์ : @iknowcal
คำค้นหา:
calibration terwin equipment test pressure melt simulator transducer