Fine Tek Flow Switchs

WORKING PRINCIPLE
Flow Switch can detect liquid movement in pipes.When the liquid is static or nonexistent, the spring
is fully extended pulling the magnet downward and opening the switch. As flow occurs and the paddle is thrusted forward 20BC~30 C (or more) the paddle will push the magnet upward and actuate the switch (closing the circuit) The length of paddle can be adjusted to the pipe's diameter.

INSTALLATION
1. The paddle length is dependent on the lowest paddle point to actuate the switch. Cut the paddle
at appropriate pipe size mark or wherever desired. The minimum is 1".
2. The paddle must be at a right angle to the direction of flow
3. The FLOW mark on the screw must be parallel to the pipe.
4. Before installing the unit to a tee pipe,apply thread seal tape to the screw and then tighten.