Bluetooth DIP Module with RP-SMA - SparkFun

This is an easy to use, long range, Bluetooth module for Serial Cable replacement and wireless communication. Now with the new SparkFun Bluetooth module based on the BGB203 IC from NXP. The BGB203 is a powerful IC with a flexible AT command set. The Bluetooth stack is completely encapsulated. The end user just sees serial characters being transmitted back and forth. Press the 'A' character from a terminal program on your computer and an 'A' will be pushed out the TX pin of the Bluetooth module.

We have pre-programmed these units with a unique MAC address, unit name of 'SparkFun-BT', and a UART interface of 9600bps.

Please note: The SparkFun BGB203 based module will be replacing the phased-out Mitsumi module. The new BGB203 has a lower cost and a more robust AT command set. The pinout of this module is the same as the Mitsumi part. The only difference between the two modules is the SparkFun module has an active low output for the Status pin.

Do not attach this device directly to a serial port. You will need an RS232 to TTL converter circuit if you need to attach this device to a computer.

Features:
  - External reverse polarized SMA connector
  - Fully configurable UART
  - UART Data rates up to 1Mbps
  - Low power sleep mode
  - Compatible with all Bluetooth products that support SPP (almost all do)
  - 3.3V operation
  - Status pin
  - Bluetooth v1.2 compatible
  - Class 1 power output



ข้อมูลเพิ่มเติม www.warf.com