ELECTROMAGNETIC CHUCK

The coil system in the chuck Electrofine is designed to spread the heat optimally on the whole surface of the chuck.  This is important for the machining of small and thin steel components  for which these chucks are designed. Electrofine can be produces  in both finishes  – with a “fine” or “microfine” pole plate. The magnetic field is constant  across the entire pole plate surface. On request it is possible to change the poling to longitudinal. The chuck is fed with the direct current of 110 V. The power supply can be done through the control unit which also widen possibilities of the chuck. 

Construction:         

• Solid and waterproof design         
• Electromagnetic system with more coils         
• Low construction height         
• Power supply – direct current of 110 V         
• Version microfine: pole plate with transversal poling – pole pitch 1.9 mm (1.4 mm steel and 0.5 mm brass)         
• Version fine: pole plate with transversal poling – pole pitch 4 mm (3 mm steel and 1 mm brass) 

Usage:         

• Grinding of small and thin components – pole pitch 1.9 mm         
• Grinding of small and medium components – pole pitch 4 mm         
• Dry grinding and grinding with cooling liquid 

Suitable control unit:         

• Available CUE and CUET         
• More info in section Control Unit           

Accessories:         

• Stop-bars          
• Set of clamps         
• Cable 3 m 

Other dimensions and voltage are available upon request. To achieve a larger clamping surface, several chucks can be joined without gaps

ขนาดที่มีสต๊อคดังนี้

ขนาด 450x150mm

ขนาด 500x200mm

ขนาด 600x300mm

หมายเหตุ สินค้าต้องใช้งานร่วมกับชุด controller