PASTEL ASSOCIATE CO.,LTD.
บริษัท พาสเทล แอสโซซิเอท จำกัด
โพสเมื่อ
Sharp Edge Tester,Sharp Edge Tester SET50,Sharp Edge Tester,Instruments and Controls/Laboratory Equipment
รหัสสินค้า
NANA-166202
ชื่อสินค้า
Sharp Edge Tester
แบรนด์
Sharp Edge Tester
โมเดล
Sharp Edge Tester SET50
รายละเอียด:

Specifications: MADE IN USA

This product was designed specifically for Underwiter’s Laboratories 

Underwriters Laboratories has released a “Standard for Determination of Sharpness of Edges of Electrical Equipment,” U.L. 1439. This standard calls for the use of the Sharp Edge Tester in order to provide an objective and uniform test method for determining compliance with an existing safety requirement.

Most U.L. standards covering consumer products contain a subjective requirement such as “an edge, projection, or corner of an enclosure, opening, frame, guard, knob, handle, or the like, shall be smooth, well rounded, and not sufficiently sharp to constitute a hazard.” 
Based on recent publications, it is evident that the sharpness of edges on consumer products is important to many government agencies like the Consumer Product Safety Commission and the National Bureau of Standards. Comment from the industry — where thousands of Sharp Edge Testers are in use — favor the general design concepts of this U.L. chosen Sharp Edge Tester over all others.

 

 

How to use:

Product Safety Testing Has Never Been This Easy 

1. Slide the Tape Cap all the way on to the pressure head of the Sharp Edge Tester with the black center guide line and the uncovered portion 

    of the red plastic cap facing up.

2. Position the tape covered pressure head on the edge of the item to be checked for sharpness. Holding the clam shell base in your hand, 

    press down on the tape covered head until the arm and the tool form a straight line.

3. Move the pressure head two inches along the edge and then back again to the starting point. Then withdraw the tool from the edge. 

    The total distance of engagement between the edge and the tape-covered head is therefore 4 inches.
4. Examine the tape cap to determine whether or not penetration has occurred through the two-sensing layers. If penetration has occurred, 

    the black indicating tape will be visible through the resulting cut. The application of the Sharp Edge Tester to an edge with acceptable 

    sharpness  will not result in the cutting through the two outer layers of the sensing tape.

คำค้นหา:
tester set50 sharp edge

บริษัท พาสเทล แอสโซซิเอท จำกัด

PASTEL ASSOCIATE CO.,LTD.

99/284 ต.บึงคำพร้อย อ.ลำลูกกา จ.ปทุมธานี 12150

020232353
020232353

Contact: กวี อารีพงศ์