Thin section grinder

The Hillquist Thin Section Grinder
is the perfect companion to the Hillquist Thin Section
Machine.  The Hillquist Thin Section Grinder is used to
grind rough cut samples before mounting and hand
finishing of thin sections.  The interchangeable diamond
laps make for rapid material removal
without contamination or undercutting.

• CABINET - one piece molded fiberglass
• LAP - 8" x 3/8"full coat metal bonded diamond
• MOTOR -1/4 HP-permanent magnet D.C.
• VARIABLE SPEED - full wave SCR control - 1 to 350 RPM with constant torque
• DRIVE - maintenance free gear belt
• ARBOR - 3/4" ground and polished steel - factory lubricated sealed bearings - 8" diameter anodized aluminum base plate
• COOLANT SYSTEM - two compartment settling tank - submersible pump - compatible with water and oil base coolants - control valves
• DIMENSIONS - 26" x 22"x 10'
• WEIGHT - 43 lbs.

Diamond laps of varying mesh size are easily changed in seconds.

Variable speed with full torque through entire speed range.