Dispenser Controller

- Digitize Control Panel.
- Instant adjustment shot time.
- Teaching memory dispensing setting model.
- Digital display of air pressure
- Dispense controlled by connected sequencer.

Standard Specification

Control method : Electronic/Pneumatic system

Power supply  : DC24V (Fixture AC100~240V Power adapter)

Power consumption  : Max. 17W

Air source  : Max. 0.99Mpa

Operating air pressure  : 0.05~0.70Mpa

Shot time range  : 0.010~9.999sec.

Operating mode  : Time mode (metered shot), Steady mode (continuous shot)

Display section  : LED Digital Display of air pressure

Control Signal Port    Shot Signal    /When select non-voltage mode : Capacity over 20mA of N.O.contact
(Foot switch port)     (Input)         /When select input voltage mode : DC5~24V

I/O Connect port      Start/Stop       /Input voltage DC10~30V, ON current : more than 3.5mA
                             (Input)           /OFF current : lower than 1mA
                            Mode/Shotting  /Non-voltage contact : DC30V, 20mA
                             (Output)

Vacuum function  : Built-in vacuum transducer

Operating temperature  : +5'C~+40'C