รายละเอียด:
MANOSTAR Pressure Transmitter
General Purpose Type
Model : EMT1A0FVD10
EMT1 : MANOSTAR Pressure Transmitter EMT1 General Purpose Type
A : Type, Drip-proof Indoor-use Type
0 : Output, Two Wires Method From 4 to 20 mA DC
FV : Piping Connector, For Vinyl or Plastic Tube
D : Unit, Pa
10 : Pressure Range, Max. Value of Scale
- Pressure Range : 0 to 10 Pa
- Accuracy (at 20°C) : ± 2 % FS
- Temperature Characteristic (Zero + Span) : ± 0.2 % FS/°C
- Withstanding Pressure of Receiving Element : 10 kPa
- Output and Transmission Method : Two Wires Method, Output Signal From 4 to 20 mA DC (Load Resistance 500 Ohms or Less), Power Supply Voltage 24V DC ± 10 % (Ripple Within 0.2 V P-P)
- Pressure Measuring Method : Measuring Difference Pressure
- Gas to be Measured : Air or Non-Corrosive Gas (Not Liquid)
- Pressure Receiving Element : Diaphragm (Silicone Rubber)
- Material of The Outer Case : Aluminum Die-cast, Painted Outer Case Surface (Paint Color Gray)
- Withstanding Pressure of Instrument Body : 500 kPa
- Standard Installation Position : Upward Horizontal (0° ± 5°)
- Conversion Method of Electric Signal : Variable Inductance
- Insulation Resistance : Between Each Terminal and Case, 20M Ohms or More (500VDC Megger)
- Medium and Ambient Temperature : 0 to +50°C (No Freezing)
- Ambient Humidity : 90% RH or Less (No Dewing)
- Withstanding Vibration : 5 to 10 Hz Amplitude : 10 mm, 10 to 50 Hz Acceleration : 39 m/s2 (Each Two Hours on Tri-Axial Directions)
- Withstanding Impact : 100 m/s2 (Each Two Hours on Tri-Axial Directions)
- Applicable Piping : Vinyl, Plastic or Rubber Tube (I.D. 6)
- Mass : Approximately 1100g
Mfg. YAMAMOTO ELECTRIC WORKS CO., LTD.
Made in Japan