Belt Conveyor Emergency-stop Switch
|
Reset system | |
Self-reset
Manual-reset | |
|---|
|
Required force of pull cord | |
49±9.8N(5 ± 1kgf) | |
|---|
Pull Cord Switch is an emergency switch to stop the belt conveyor instantly when an accident happens. Since the Pull Cord Switch is so designed that it should be installed at the side of belt conveyor and the pull cord should be mounted along conveyor, the switch can be actuated at any position. According to the Industrial Safety & Health Regulations, it has been assigned to install the Pull Cord Switch to belt conveyor in Japan
For Sway and Deviation Detection
Reset system
Self-reset
Contacts
1 contact for alarm
1 contact for emergency stop
Belt Sway Switch is a protective switch for detecting the meandering (sway or deviation) of belt conveyors, and sends out an alarm signal and an emergency stop signal.
Suited to be used for belt breakage prevention and orefalling prevention due to the belt sway. Widely used in iron and steel, cement and chemical plants, thermal power
plants, etc., since it is essential for safety operation of belt conveyors.
Overspeed and Slip Detection
|
Rated speed |
2000P/min Max. | |
|---|
|
Actuating speed |
2P/min to 999P/min | |
|---|
SPEED SWITCH is a non-contact type motion sensor to detect the revolving speed of machinery shaft and operates output relay when the speed reaches setting value.