MITSUBISHI Manual Power Supply
Model : LD-40PSU
FUNCTION :-
The LD-40PSU manual power supply device is a constant-voltage controlled power supply device for the powder clutch/brake and hysteresis clutch/brake. Voltage is controlled with the dial on panel, external signal voltage, or external variable resistor.
FEATURES :-
1. External control signal (remote ON/OFF)
With an external signal of 0-5V, output voltage can be controlled remotely in the range of 0-24V.
2. Output ON/OFF function
Output can be turned on or off with the buttons on the panel or by using the external remote contact signal (RC signal)
3. Inertia compensation function
In the manual tension control mode, stop timer operation and inertia compensated output in response to the RC signal are possible.
4. Load short-circuit protection/warning
The short-circuit protection circuit is triggered by a load short-circuiting. The LED on the panel turns on when the circuit is triggered.
5. Two-level output setting
This device can be set to supply two difference levels of output voltage : one with and the other without RC input.
The one without the RC input can be set to provide weak excitation etc.
Specification :-
- Power Supply : 100-240V AC (+10%, -15%) 50/60Hz
- Power Consumption : 200VA (At 24V DC, 3.8A)
- Output (Power amplifier output) : 24V DC 3.8A or less
- Output (Power supply for variable resistor) : 5V DC 10 Ma or less, External variable resistor 500-2 K?
- Input (Analog signal) : Input signal for control 0-5V DC
- Input signal (Contact signal) : Remote output ON/OFF 12V DC/Ma Internal power feed
Mfg. : MITSUBISHI ELECTRIC CORPORATION
Made in Japan